The application scope of stamping processing technology in Kunshan is becoming increasingly widespread. Many accessories, including tools, are stamped by machines. For example, the shape of a car lampshade is known to be elliptical, which is difficult to produce. By using stamping technology, it can be achieved very well. So how is stamping processing done? First, when you get the stamped part, you need to observe its edge line. Use a machine to separate the stamped part from the blank along the edge line. After successful separation, you can stretch or bend the stamped blank according to customer needs to make it into a fixed shape, and then shape it.
A qualified stamping parts processing factory is not simply about producing products and directly promoting them to the market to complete the task. After each product is produced, the stamping parts processing factory first needs to inspect whether the product meets the standards. There are various methods of inspection.
1. Touch inspection: The hardware stamping parts factory uses clean gauze to wipe the surface of the outer covering parts clean. The inspector needs to wear touch gloves and touch the surface of the stamped part along the longitudinal direction, which depends on the inspector's experience. If necessary, the suspicious area that has been detected can be polished with an oilstone and verified, but this method is still an effective and rapid inspection method.
2. Oil stone polishing:
(1) Firstly, wipe the surface of the outer covering with clean gauze, and then polish it with an oilstone (20 × 20 × 100mm or larger). For areas where the hardware stamping parts manufacturer has arcs and difficult to reach areas, use relatively small oilstones to polish them
(2) The selection of oil stone particle size depends on the surface condition (such as roughness, galvanizing, etc.). Suggest using fine-grained oilstone. The direction of oilstone polishing is basically along the longitudinal direction, and it fits well with the surface of the stamped part. Some special parts of the metal stamping parts manufacturer can also supplement horizontal polishing.
